Dg700 manual

For purposes of this manual a baseline pressure reading is defined as a pressure measurement made under a specific operating condition, which will be used to determine the change in pressure created by a change in the operating condition. Page Restarting The Baseline Measurement. Seller warrants that this product, under normal use and service as described in the operator’s manual, shall be free from defects in workmanship and material for a period of 24 months, or such shorter length of time as may be specified in the operator’s manual, from the date of shipment to for the DGFile Size: KB. Operation Manual for Exhaust Fan Flow Meter Chapter 1 Introduction 1 Chapter 2 Exhaust Fan Flow Meter Test Procedure 2 Connect the Metering Box to a Pressure Gauge 2 Select the Door Position on the Metering Box 3 Attach the Handle to the Metering Box 3 Turn On and Configure the Pressure Gauge 4.

About This Manual • The instructions in this manual are for model STR-DG Check your model number by looking at the lower right corner of the front panel. In this manual, models of area code CEL is used for illustration purposes unless stated otherwise. Any difference in operation is clearly indicated in. No part of this manual may be reproduced, in any form or by any means, electronic or mechanical, including photocopying, without the express written permission of DiCon Fiberoptics. We have reason to believe that a number of the company and product names appearing. Some DOOGEE Mobile Phones Manuals PDF are above this page. Doogee is a young Chinese manufacturer, which is a division of the Chinese concern www.doorway.ru latter specializes in the production and maintenance of telecommunications equipment. The company has research laboratories and full-cycle plants, and the production receives international quality certificates.

g) Prepare the building for a Blower Door test as described in the Blower Door manual. 3. Connect tubing to the Duct Blaster Gauge. a) Select a location to measure duct pressure. The best location for measuring duct pressure is often in the supply trunkline or plenum. Drill a small hole (1/4" to 3/8" OD) into the duct to. The information provided within this manual has been carefully reviewed for technical accuracy. DiCon Fiberoptics reserves the right to correct technical or typographical errors at any time, without prior notice. In no event shall DiCon Fiberoptics be liable for errors. On Amazon you can find a lot of unofficial manuals, maybe there is also something for the DOOGEE TITANS2 DG To Amazon* Unfortunately there is no english manual available for the DOOGEE TITANS2 DG yet.