Elk-m1xep manual






















 · ELK-M1XEP Manual. The Elk M1XEP is the ethernet interface for the Elk M1 alarm panel. This allows users or programmers to access the device remotely over the www.doorway.ru: JoJosida Samulrajas. ELK-ER Set JP1 to 'Normal'. DATA A +-+-See Note 2 Data Bus Terminating Resistor See Note 1. Data Bus See Note 1 J7 Amp PTC protected ELK PRODUCTS, INC. HILDEBRAN, N.C., , USA 1 1 Cross Platform Control PSC05 †† or Equivalent ELK-M1 Strip Wires to 1/4" Length Strip + Ohm EOL-NEG Z16 2. OUT 1 †† for speaker(s) ONLY (4.  · Refer to the instructions on the bottom of page 25 in the ELK M1XEP Installation Manual. Make sure your M1XEP is in the DHCP mode. If you haven't already done so, you need to go through the enrollment procedure, but that won't stop the M1XEP from appearing on the Ethernet network.


The ELK-M1XEP is an Ethernet Appliance with a RS Serial Port Interface. It may be used to connect a control in the M1 Family to an Ethernet network. It features email event notification and FIPS compliant encryption algorithms for security sensitive environments. It is powered by an ELK-P 12 Volts DC, Amp plug-in power supply/adapter. ELK-M1XEP Manual. The Elk M1XEP is the ethernet interface for the Elk M1 alarm panel. This allows users or programmers to access the device remotely over the internet. The ELK-M1XEP is an Ethernet Device Server with a RS Serial Port Interface. It may be used to connect a Control in the M1 Family to an Ethernet network. ELK-M1XEP M1 Ethernet Interface with a RS Serial Port Interface. ADI #:EK-M1XEP Model #: ELK-M1XEP Name #:ELK-M1XEP ETHERNET PORT F/M1.


ELK-M1XEP Manual. The Elk M1XEP is the ethernet interface for the Elk M1 alarm panel. This allows users or programmers to access the device remotely over the internet. ELK Products Inc US Hwy Connelly Springs, NC () info@www.doorway.ru ELK-M1XEP Installation Manual Page 6 Page 7 Values between and are valid. The recommended (default) port is If you intend to access the Control through the Internet, this port should be mapped (port forwarded) to outside the local network via a router. ELK-M1XEP Installation Manual Page 7 Page 8: Send Changes To M1Xep And Save.

0コメント

  • 1000 / 1000