How to add manual transmission fluid integra

Pull the dipstick from the tube and check the fluid level on the dipstick. If it is below the full mark, add Honda ATF Z1 transmission fluid until it reads full. Insert the dipstick back into the tube, making sure that it is all the way into the tube so that it does not leak oil past the seal.  · A plug and a filler. The lower one is the plug and you use a ratchet on that, no socket just a ratchet. 1) You take that off and drain the fluid out. 2) Then you put it back in and take the filler bolt off (you can take this off first and it will drain faster, I think it's a 17 mm). 3) Then the tranny will take I believe quarts or about.  · Use a long rubber hose and a funnel to feed the transmission fluid down. Keep filling until the fluid starts to run out that hole. This means you've reached the top and you can stop. Put the plug back in and tighten. Keep in mind, for a manual transmission, you DO NOT use automatic transmission fluid (DEXRON II or III, or any other ATF types).

Short video about transmission funnel that I have been using for 20 www.doorway.ru similar funnel can be purchased here www.doorway.ru automatic flui. . #6. by all means change the fluid, but you dont have to use the honda genuine stuff. Some people think that the GM syncromesh is better than the honda sutff, others say vice versa. changing your trans fluid is a part of maintaining your car, but you dont have to use the honda genuine MTF that you will pay a lot for. How to Drain Transmission Fluid, Transmission fluid is used as a lubricant in different vehicles for the components of transmission to optimize performance. There are two types of transmission fluid automatic and manual transmission fluid. In vehicles, with automatic transmission, the transmission fluid sometimes also acts as a coolant to maintain vehicle temperature.

Visit me at: www.doorway.ru Honda manual transmission fluid is not a difficult task in my opinion. I think the hardest part is figuri. Manual Transmission GLS Mopar PN NV add pt (L) friction modifier when refilling Transmission Synchromesh MTF AX Manual Transmission 5-speed GL-3 SAE 75W PN or equivalent Getrag Manual Transmission 6-speed AP4 ATF+4® Automatic Transmission Fluid Mopar ATF+4® (MS) PN AA(quart) and. Drain and fill per the normal procedure then install the plug once its full remove vent cap and add 1/2 qt more thru the vent hole. This will raise the fluid level up higher providing more lube to 4th and 5th gears and most importantly keep the Input bearing lubed and help keep it from failing which is a very comon problem in a honda transmission.